1. You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Album: KF6IRK

uh ... my very own album? Cool

KF6IRK

Updated Mar 2, 2013
kf6irk 'Kapt IRK' avatar pic 2013  
WJW smaller pic  
Thought this looked like Gary WJW(2)  
Weber 40IDF carbs on a fresh 2.0L Type-4 engine.  
Elecraft KX3 ... my next HF purchase - after I sell a SGC SG-2020 and a Tokyo Hi-Power HT-750 HT (6m/15m/40m) ...  
This is a 2.0L Type-4 engine that we temporarily installed in one of my 914s until my new 'Raby 2056' was ready. My friend, Thomas, did most of the installation since my back was fucked up.  
My buddy Robert's Rotary-powered 914. Crashed it on Glendora Mountain Road ... OUCH. Almost a shear cliff over the edge there ... them big boulders totaled the car, but saved his bacon!  
Solar Water Heater This was my first attempt at constructing a solar water heater system. The system consists of a 55 gal. tank, a 24vDC SHURflo 3.0 gal/min pump and a 200-watt, 24-volt mono-crystalline PV panel. The Pump draws 3.5 Amps, the PV outp  
My 'Man Cave' (2012) ... it looks worse now (no elbow room) :(  
These are a couple of 40-watt multi-crystalline solar panels I purchased from DiscountSolar (on ebay) last year. Free shipping, but CA tax. These were $160. with tax, making them $2./watt ... not too bad. Construction is very good, and being multi, the  
The rack assembly I fabricated for the 40-watt panel (x2). Racks were fabricated using left over scrap materials. Bases are fiberglass UniStrut, cross member is shallow steel Unistrut. Hinges made from aluminum ''U' channel and struts from some 'L' ang  
Here's the little '83 XT-200 I picked up in the summer of 2012. I really miss my old '72 250 DT1, but I decided to go 4-stroke this time.  
Tokyo Hi-Power HT-750. 6m/15/40m cw/ssb HT. Cool little radio with an extremely hot receiver.  
My main hobby  
My garage station from a few years ago. Now running a TS-2000 and receive on an IC-R7000 when duplexing  
Making a new solar 'collector' from a discarded 'doggy door' insert (from a sliding glass door cut down to 54"x15"). The box is constructed from 2 x 4s and 3/8" plywood (painted black).  
Testing the new solar collector. The temperature inside the box rose to over 200F degrees in less than 30 minutes ... better than I thought it would produce.  
Firewood and target backers for Cuddeback 2013  
Two target backers so far (30" x 34") for Cuddeback 2013  
Bike rack assembled and mounted on the Tacoma  
Loading Photos......
Loading Photos......

Share This Page