You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Can someone tell me how to wind T1 & T2 in the diagram the instructions say :
T1 5 Watts
The 5-watt version has a much lower Base impedance. In this case it is around 1 Ohm for each transistor. If the input is 50/75 Ohms then the impedance ratio is about 64:1+1 which is a nice round figure of...
well this be a better option captain http://electronicsandbooks.com/eab1/manual/Magazine/A/ARRL American Radio Relay League US/Arrl.Periodicals.2003.(Qst.Qex.Ncj)/Arrl.Periodicals.2003.(Qst.Qex.Ncj)/q200306.pdf its on page 35
i know how to read schmatics the only thing holding me back is how...
Ok some of you may laugh for me asking this but i was wanting to know if i could make something like this http://www.freeradio.org/documents/6watrev2.pdf for cb. i have most the parts and think it would be a cool little project i could make to put with my small uniden 510 so if anyone could...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.