• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Search results

  1. J

    heathkit sb220

    Wouldn't you expect to see most of the normal voltage even on a 110 volt circuit? At least when there was no load? Sounds like the transformer or the plug is still wired wrong if it only shows 1000 volts. Just wondering because I recently had a Henry do the same thing and it had a 110...
  2. J

    old varmint XL-250, please advise!!

    Here is a link for tuning and drive information and a schematic. Varmint Almost every one of these I've seen that still has the gold colored electrolytic caps has them go bad shortly after starting to use them again after a long storage period. Most of them look pretty nasty if they are...
  3. J

    Afterburner 482 help

    Not sure if it will help but you can get the schematic at CB Tricks if you want to check out the keying circuit a little closer. Hygain index at CB Tricks
  4. J

    light out in pyramid ps46

    Did you ever get an answer from Pyramid. I find it is better to call them than wait on an email. If you haven't got it by now, here is there contact info. Pyramid Car Audio Inc. 1600 63rd. Street Brooklyn N.Y. 11204 1-800-444-5671 Local (718) 535-1800 Fax (718) 236-2400
  5. J

    D&A Raider

    The tubes that it came with are 6JG6 or 6JT6. The 6KV6 will work and have more output but they cost a lot more. The 6AQ5 is for the keying circuit and is not a driver tube.
  6. J

    D & A Hawk

    Hawk Most people have the single tube version and I've never seen that schematic. The two tube version like you have is posted on CB Tricks. This is very similar to the Hornet without the meter. The small tube is part of the keying circuit so there is no driver, just the two tubes. You can...
  7. J

    Parasitic Suppressors

    Can anybody tell me what size wire to use to make some parasitic suppressors for a D&A Phantom? Does it have to be tinned or will copper work. Also, using the resistors available today, when do you put the resistor inside the coil and when should you put it outside. I remember reading something...
  8. J

    Which wire goes where?

    If you haven't figured it out yet, you might call RF Limited they are usually real helpful. 1-877-624-6869 </p>
  9. J

    Channel Chart

    You didn't say what radio you had. Anyway, here is a place you can find several charts. www.hotspotcb.com/cbshop/charts.html </p>
  10. J

    Hy-gain Big Gun II

    Does anyone have any of the plastic parts that hold the wires for this antenna. I found a new one but the guy lost some of the pieces. </p>
Top Bottom
Back