Search results

It looks like your car radio is a double DIN sized radio. That would allow you to install an aftermarket single DIN on top with the AnyTone on the bottom into the dashboard. As for your situation... from what I can tell it looks like your stereo tapers down towards the bottom, so I don't know...

This is the mosfet that board is designed around. https://www.st.com/resource/en/datasheet/sd4933.pdf It's a 50v device with a minimum of 40v. That's where they got the 1200 watt rating from in the add. At 40v it's rated at 300 watts per device, and at 50v it's rated at 400 watts per device.

That sounds to me like it was aligned to spec. USB is supposed to be 1.5kc up and LSB is supposed to be 1.5kc down, but that's not how CBer's run. They want it on the zero, no matter what.

No, no, no... that was the gain when they were installed. As soon as you start using them, the gain drops. You'll need to pull out, at the very least, it's companion and measure it to see what the current gain is. If it were me I would test all of them to be sure they are still good.

It looks like its designed around this mosfet. https://www.nxp.com/docs/en/data-sheet/MRFX1K80H.pdf

That looks like it arced through the grommet.

I'm gonna stick with my dinosaur like equipment that works just fine. 35 year old Pluto and a TWO THIRDS KILLOWATT 667V. I might kick the sweet sixteen on every now and then for giggles.

This is what I was able to find.

Would CLR hurt it? I honestly don't know, it's just a thought.

The radio provides power to the stock mic on pin 6. I don't know if not connecting that would allow the use of an Astatic mic or not. Otherwise the wiring would be: 1. White 2. Black 3. Red 4. Not Used 5. Blue/Shield 6. Power from radio (not used for aftermarket mic) The mic may also not be...

This and a ground are where you need to connect the wire on the board.

You can make it one. It's not a hard mod to make. I did one a few years ago.

Me either. I just did a search and found it.

When covid hit they allowed online testing via ZOOM. It is still available to be taken this way. https://w9twj.com/exams/

I have a couple on the way that I'm coin to put into an old Pyramid PS-52 power supply that died on me. They should be here tomorrow so I will have a project on my plate.

It looks like a polycarbonate capacitor. https://www.google.com/search?q=polycarbonate+capacitor&gs_ivs=1

This is why I run my 667 or my sweet sixteen with my 2950DX. Keeps the radio cooler too. :D

What board is in it? It might be possible to get what you need from another model with the same board.

Switch the black and the white.