You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Not quite sure if that was a determination or a assumption. I could not find a problem in the mic socket or board. I get the same results weather I remove the squelch pot. or the mic. socket. I can not seem to find a problem with either.

Just some findings. There is a red wire that goes from a center lug in the squelch/ pa pot. that goes to pin 5 of the mic socket. Removing that wire does not correct the problem. This problem is the same in PA or CB. moving the squelch back and forth quickly will occasionally take this out of TX for a very small fraction of a second.

[QUOTE="Low_Boy, post: 666865, member: 12157"] Not quite sure if that was a determination or a assumption. I could not find a problem in the mic socket or board. I get the same results weather I remove the squelch pot. or the mic. socket. I can not seem to find a problem with either. Just some findings. There is a red wire that goes from a center lug in the squelch/ pa pot. that goes to pin 5 of the mic socket. Removing that wire does not correct the problem. This problem is the same in PA or CB. moving the squelch back and forth quickly will occasionally take this out of TX for a very small fraction of a second. [/QUOTE]

Top Bottom