You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

How bout wide banding this chassis?
Reason for asking is the low channels (below 26.765) will not lock on. I tried adjusting VCO but had no luck.

I read somewhere about removing C81 completely and replacing R84 with a 47k ohm resistor to widen it out for extra channels. Is this correct, or is there a better way other than messing around the balanced modulator IC?

The channel mod is kinda strange.
Pin 10 not cut but has a wire going to a spdt center off switch. Pin 11 track is cut with a wire on both sides of the cut going to a spdt center off switch. Then pin 12 is not cut and has a wire going to a spdt center off switch. Finally pin 17 has a wire coming off it to a spdt center off switch.

The channel mods I've seen calls for pin 10 to be cut, pin 11 not to be cut, and pin 12 to be cut.

[QUOTE="Hawkeye351, post: 840719, member: 61115"] How bout wide banding this chassis? Reason for asking is the low channels (below 26.765) will not lock on. I tried adjusting VCO but had no luck. I read somewhere about removing C81 completely and replacing R84 with a 47k ohm resistor to widen it out for extra channels. Is this correct, or is there a better way other than messing around the balanced modulator IC? The channel mod is kinda strange. Pin 10 not cut but has a wire going to a spdt center off switch. Pin 11 track is cut with a wire on both sides of the cut going to a spdt center off switch. Then pin 12 is not cut and has a wire going to a spdt center off switch. Finally pin 17 has a wire coming off it to a spdt center off switch. The channel mods I've seen calls for pin 10 to be cut, pin 11 not to be cut, and pin 12 to be cut. [/QUOTE]

Top Bottom