parts list
1 1/4" fence top rail (boom and top mast section)
1 1/4" PVC (2 pieces for boom end sleeves holding spreader tees)
1" PVC ( 8 sections for spreaders)
1" x 48" wood dowel (inside spreaders for rigidity)
1" PVC 4-way cross (2 for spreader center joints)
3/4" PVC (8 sections for spreaders)
1" PVC couplers (8 for spreader joints)
1" x 3/4" PVC bushings (8 for spreader joints)
3/4" PVC caps (8 for spreader tips)
3/4" PVC tee (1 for driver wire/feedline terminal connection)
16" wire shelf supports (8 for spreader rigidity)
project box (1 for 75ohm match section to pl239 solder joint)
u-bolts (2 for boom connection to angles)
threaded eye bolts (2 for PVC cross spreader center joints)
myriad bolts, screws, and nuts
Steel shelf angle brackets (2 for mast to boom connection)
wood squares (2 for spreader rigidity)
14ga wire of sufficient length
PVC boom end sleeves were shaped to match profile of 1" PVC crosses joining center of spreaders. 1/4"hole was drilled through the center of PVC crosses, 1/4" x 3" eye bolts were reversed through the holes into the 1 1/4" PVC boom end sleeves and secured with 1/4" bolts across sleeves through the eye of eye bolts. Sleeves allow for both mounting and sliding spreaders in or out to tune.
