You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Changing the logic level of pin 16 on the RCI 8719 PLL chip will give you a +10kc or -10kc depending on channel selector. Cut the trace at pin 16 as shown and bridge the cut with a 4.7K ohm resistor. You can then wire the center contact of a spdt on-off-on switch to the PLL pin side of the 4.7K resistor Pin16. Wire one outside contact of the switch to Pin 9 for 8 volts and the other outside contact to Pin 18 for board ground.

...remember all your ducks need to line up in a row

[QUOTE="SmackDown, post: 96512, member: 1451"] Changing the logic level of pin 16 on the RCI 8719 PLL chip will give you a +10kc or -10kc [b]depending on channel selector[/b]. Cut the trace at pin 16 as shown and bridge the cut with a 4.7K ohm resistor. You can then wire the center contact of a spdt on-off-on switch to the PLL pin side of the 4.7K resistor Pin16. Wire one outside contact of the switch to Pin 9 for 8 volts and the other outside contact to Pin 18 for board ground. ...remember all your ducks need to line up in a row [/QUOTE]

Top Bottom