You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Yup, checking bias on this thing, they have the center tap going to relay. Then one pin goes to a resistor to case for cutoff or idle bias. The other side of relay when activated goes to a SK536 which is an 11V 50W diode. Using diode function on meter, it is open, other way I get continuity. It measures about 1.5M one way. The other way it is open. So it tests good. Funny thing was the nut to tighten it was loose. Took it off by hand. No wrench needed. I may just string a bunch of 1N5408's together for about 11 volts and see what happens. Just tryin to get it up and running before it gets modified or put back to stock.

[QUOTE="Crusher, post: 234978, member: 3746"] Yup, checking bias on this thing, they have the center tap going to relay. Then one pin goes to a resistor to case for cutoff or idle bias. The other side of relay when activated goes to a SK536 which is an 11V 50W diode. Using diode function on meter, it is open, other way I get continuity. It measures about 1.5M one way. The other way it is open. So it tests good. Funny thing was the nut to tighten it was loose. Took it off by hand. No wrench needed. I may just string a bunch of 1N5408's together for about 11 volts and see what happens. Just tryin to get it up and running before it gets modified or put back to stock. [/QUOTE]

Top Bottom