You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Ok.....here is the info you asked me for..

With mirror board still in, AM chan 20, freq. cntr on TP3
16.50985 with mic gain off
16.586 and drifting with mic gain full open, no mod.

L43 peaks just fine and @ peak, the slug appears to be roughly 50% down the can.

I did change L35 to a 4 turn coil

L31 looks factory
L30 has be spread a bit ( not by me)
L29&28 look like they may have bit touched but not bad. (Again...not by me)

I am reading DC Volts on the mixer pins and the voltages I posted are what was read.

I will post my findings on R261 shortly

As for the alignment..... I thought I got thru it all really well.
They radio responded nice and everything on my scope and wattmeter looked good.
I'm by no means an expert on radios but I did buy this thing used and it didn't perform well at all.
It still doesn't perform well. Lol
But I am making progress with your help.
Thank you much so far

<blockquote data-quote="Jdb0367" data-source="post: 551661" data-attributes="member: 47152">Ok.....here is the info you asked me for..With mirror board still in, AM chan 20, freq. cntr on TP316.50985 with mic gain off16.586 and drifting with mic gain full open, no mod.L43 peaks just fine and @ peak, the slug appears to be roughly 50% down the can.I did change L35 to a 4 turn coilL31 looks factoryL30 has be spread a bit ( not by me)L29&amp;28 look like they may have bit touched but not bad. (Again...not by me)I am reading DC Volts on the mixer pins and the voltages I posted are what was read.I will post my findings on R261 shortlyAs for the alignment..... I thought I got thru it all really well.They radio responded nice and everything on my scope and wattmeter looked good.I&#039;m by no means an expert on radios but I did buy this thing used and it didn&#039;t perform well at all.It still doesn&#039;t perform well. LolBut I am making progress with your help.Thank you much so far</blockquote>

[QUOTE="Jdb0367, post: 551661, member: 47152"] Ok.....here is the info you asked me for.. With mirror board still in, AM chan 20, freq. cntr on TP3 16.50985 with mic gain off 16.586 and drifting with mic gain full open, no mod. L43 peaks just fine and @ peak, the slug appears to be roughly 50% down the can. I did change L35 to a 4 turn coil L31 looks factory L30 has be spread a bit ( not by me) L29&28 look like they may have bit touched but not bad. (Again...not by me) I am reading DC Volts on the mixer pins and the voltages I posted are what was read. I will post my findings on R261 shortly As for the alignment..... I thought I got thru it all really well. They radio responded nice and everything on my scope and wattmeter looked good. I'm by no means an expert on radios but I did buy this thing used and it didn't perform well at all. It still doesn't perform well. Lol But I am making progress with your help. Thank you much so far [/QUOTE]

Top Bottom