You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

The spacer disk is a non-conductive plastic material. It is the end of an empty wire spool. I will fix the angle of the wire connectors holding the four radials to get a consistent angle from end to end. I am prepared to insert spacers for a more distant standout at the radial mount points, but can do the bent to proper angle fix first.
And I can make the gamma to the suggested specs.
I have noticed more SWR response at the two extremities you ask about, but so far the closest I've gotten is about 3.1:1 well above the 27.205 I'm reaching for as a low point. With some adjustments I get only from a 4___ thru 6___ SWR.

Thanks SW

[QUOTE="HomerBB, post: 226145, member: 8569"] The spacer disk is a non-conductive plastic material. It is the end of an empty wire spool. I will fix the angle of the wire connectors holding the four radials to get a consistent angle from end to end. I am prepared to insert spacers for a more distant standout at the radial mount points, but can do the bent to proper angle fix first. And I can make the gamma to the suggested specs. I have noticed more SWR response at the two extremities you ask about, but so far the closest I've gotten is about 3.1:1 well above the 27.205 I'm reaching for as a low point. With some adjustments I get only from a 4___ thru 6___ SWR. Thanks SW [/QUOTE]

Top Bottom