You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Yes it is conductive it's a piece of 1/2" aluminum plate. It is held by two set screws in the side that push against the pvc

[ATTACH]728[/ATTACH]

The "L" bracket is attached to the aluminum plate and so are the radials

The ground of the coax hooks to the "L" bracket and the "L" bracket hooks to the mounting plate and the mounting plate hooks to the radials. One end of the coil hooks to the "L" bracket and the other end hooks to the vertical element. The center of the coax hooks to a jumper along the coil.

I see this thread was moved to the CB section, but the antenna was cut (22') to be in between 11m and 10m so I could use it both for CB and Ham

I think first thing tomorrow I will pull out the 7/8 bar and see what happens

[QUOTE="W9WD, post: 142069"] Yes it is conductive it's a piece of 1/2" aluminum plate. It is held by two set screws in the side that push against the pvc [ATTACH]728.vB[/ATTACH] The "L" bracket is attached to the aluminum plate and so are the radials The ground of the coax hooks to the "L" bracket and the "L" bracket hooks to the mounting plate and the mounting plate hooks to the radials. One end of the coil hooks to the "L" bracket and the other end hooks to the vertical element. The center of the coax hooks to a jumper along the coil. I see this thread was moved to the CB section, but the antenna was cut (22') to be in between 11m and 10m so I could use it both for CB and Ham I think first thing tomorrow I will pull out the 7/8 bar and see what happens [/QUOTE]

Top Bottom