Reply to thread

Marconi,

You know I am the worst of folks to comment on a model being the modeling novice I am, but when I looked at this one of the

Skeleton Sleeved Dipole I saw exactly the same as with your 5/8 wave model above.

 

When I counted up the vertical of both of the Skeleton Sleeved Monopole models I found the one not showing inversion agreement between the red current indicator lines and the tabular current data was the one showing a red line crossover of the vertical in segment 8 of the central radiator, and the one where the tabular current data showed inversion was occurring at segment 10, which was the model with the red indicator line not crossing over the central radiator. In other words, the models showed inversion in the tabular current data when the red indicator line stayed on the same side of the central vertical radiator with a simple bump in toward the central vertical radiator.* 

 

Once again, whether I am following all this correctly may be suspect, but I was trying to figure a little of this out as a learning experience.

 

* red line crossed over = no tabular current data inversion indicated

red line stayed on same side = tabular current data inversion indicated???