You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

I just used a factory chrome plastic knob and drilled it out with a 1/4” drill bit, and it has a snug press fit on the shaft, but not so tight that you can’t pull it back off.

I can’t remember I will check when I can get back to the radio... I will say that adding the ten turn did not affect how much it will slide. My clairifier is wild also,it slides a lot...adding the ten turn helped with drifting. My radio will drift about 100hz slowly over a couple hours

[QUOTE="red97k1500, post: 674786, member: 28504"] I just used a factory chrome plastic knob and drilled it out with a 1/4” drill bit, and it has a snug press fit on the shaft, but not so tight that you can’t pull it back off. I can’t remember I will check when I can get back to the radio... I will say that adding the ten turn did not affect how much it will slide. My clairifier is wild also,it slides a lot...adding the ten turn helped with drifting. My radio will drift about 100hz slowly over a couple hours [/QUOTE]

Top Bottom