Hi guys. I've received the MB3756 today and I did like you told me,
I desoldered pin 9 at the PLL, and tested both pin 1 on the
voltage regulator and the pin 9. Pin 1 on the MB3756 tested 8.3V,
and I also got 8.3V at pin 9 on the PLL. I then soldered pin 9 of
the PLL back and measured voltage. Also 8.3V. But most of the
PLL voltages are all messed up, ie:
pin 1- 3,15V instead of 3,4V ( this one is not very bad )
pin 2- 1,93V instead of 4,28V, pin 3- 0,03V, pin 4- 3,15V
instead of 3,45V, pin 5- 3,15V instead of 3,45V, pin 6- 0,03V
instead of 8V, and so on. Pin 9 is correct though, at 8,3V.
I still have no TX, I mean the light doesnt change from green to red
when pressing the PTT.
Maybe the PLL is out?
Any ideas?
Thanks,
João G.
