You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Oh geez guys, now I know what you meant.

I just bent mine up 90 degrees when I couldn't seat them and desolder enuff of their cheap solder.

I just folded 90 degrees and pressed in then folded over the tab...nothing glorious.

Later after a second set - I just bent and snipped off the copper lead "foil" and press in- solder then bolt- the solder 'dammed" up against the pills copper - like an edge connection.

Did up a RD16HHF1 missing diode page too...on the 200 but I had taken some pics - will try to look those up...seems the diode went missing - and if you turned up the trim just a notch - it was too far and blew the part...Nomad you had some thing on that too.

Attached are two I've found so far...
[ATTACH=full]24620[/ATTACH]
This is for a 150....

[ATTACH=full]24621[/ATTACH]

<blockquote data-quote="Handy Andy" data-source="post: 633814" data-attributes="member: 52309">Oh geez guys, now I know what you meant.I just bent mine up 90 degrees when I couldn&#039;t seat them and desolder enuff of their cheap solder.I just folded 90 degrees and pressed in then folded over the tab...nothing glorious.Later after a second set - I just bent and snipped off the copper lead &quot;foil&quot; and press in- solder then bolt- the solder &#039;dammed&quot; up against the pills copper - like an edge connection.Did up a RD16HHF1 missing diode page too...on the 200 but I had taken some pics - will try to look those up...seems the diode went missing - and if you turned up the trim just a notch - it was too far and blew the part...Nomad you had some thing on that too.Attached are two I&#039;ve found so far...[ATTACH=full]24620[/ATTACH]This is for a 150....[ATTACH=full]24621[/ATTACH]</blockquote>

[QUOTE="Handy Andy, post: 633814, member: 52309"] Oh geez guys, now I know what you meant. I just bent mine up 90 degrees when I couldn't seat them and desolder enuff of their cheap solder. I just folded 90 degrees and pressed in then folded over the tab...nothing glorious. Later after a second set - I just bent and snipped off the copper lead "foil" and press in- solder then bolt- the solder 'dammed" up against the pills copper - like an edge connection. Did up a RD16HHF1 missing diode page too...on the 200 but I had taken some pics - will try to look those up...seems the diode went missing - and if you turned up the trim just a notch - it was too far and blew the part...Nomad you had some thing on that too. Attached are two I've found so far... [ATTACH=full]24620[/ATTACH] This is for a 150.... [ATTACH=full]24621[/ATTACH] [/QUOTE]

Top Bottom