You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Then run a voltage check - locate J105...

The F E D silkscreen and there is a 10kHz line right there by G for board ground (large foil versus 8V runner foil to the front panel side) - see if it changes...

Sorry, when I talk Clarifier Fine coarse - just get used to looking for a voltage on this header...it's part of the bandswitch and the 10kC jump

Which may mean you have a diode array or 4008 Adder chip going bad.

[QUOTE="Handy Andy, post: 785590, member: 52309"] Then run a voltage check - locate J105... The F E D silkscreen and there is a 10kHz line right there by G for board ground (large foil versus 8V runner foil to the front panel side) - see if it changes... Sorry, when I talk Clarifier Fine coarse - just get used to looking for a voltage on this header...it's part of the bandswitch and the 10kC jump Which may mean you have a diode array or 4008 Adder chip going bad. [/QUOTE]

Top Bottom