Galaxy N channel kit for the RS 465 and Cobra 146gtl

[dss56]

Would anyone have a Galaxy N channel kit with directions they will not be using.
Or the board design so I can breadboard one.
The N kit is used for the 146gtl or the pc122 ssb radios and others that use the same pc board.

Here is a picture of what the board/kit looks like.

Willing to buy one if available or trade

 

[NZ8N]

Galaxy N kit

Has anyone seen these kits before? Im trying to get directions for install in radios. It says can install in a cobra 29. Kit has 4 wires thats all I know. Shows many more radios. The board has no xtals on it so wondering how this kit will work? And comments appreciated

www.worldwidedx.com

Channel Board For Cobra 146GTL & Uniden PC-122XL

Channel Board For Cobra 146GTL & Uniden PC-122XL: Low-cost AM/SSB radios with gPD2824 PLL chip. Expansion kits available to increase coverage but may void FCC approval.

cbworldinformer.com

 

[dss56]

Galaxy N kit

Has anyone seen these kits before? Im trying to get directions for install in radios. It says can install in a cobra 29. Kit has 4 wires thats all I know. Shows many more radios. The board has no xtals on it so wondering how this kit will work? And comments appreciated

www.worldwidedx.com

Channel Board For Cobra 146GTL & Uniden PC-122XL

Channel Board For Cobra 146GTL & Uniden PC-122XL: Low-cost AM/SSB radios with gPD2824 PLL chip. Expansion kits available to increase coverage but may void FCC approval.

cbworldinformer.com

Thanks for that info.

 

[dss56]

So as pictured this is the schematic of the Galaxy N channel kit.
Is this correct as I would like to build a few of these.
I see this schematic on a few sites and was hoping its correct.
Show with a toggle or 3 position rotary switch
Any suggestions?

 

[dss56]

So as pictured this is the schematic of the Galaxy N channel kit.
Is this correct as I would like to build a few of these.
I see this schematic on a few sites and was hoping its correct.
Show with a toggle or 3 position rotary switch
Any suggestions?


View attachment 71211

Has anyone built one to this schematic

 

[Pioneer621]

My memory is a little hazy, but I think I built that one like 15 years ago and it worked okay in a 146GTL, I’m almost certain that is the same one I built. I made it on perfboard (or maybe the board with the solder pads), with a bunch of jumper wires, which mistakes are easy to do if you make it like this. Not sure I recommend doing it, but perhaps a fun cheap project to try.

 

[dss56]

So as in post #4 i posted a schematic of the N channel kit.
The directions are for the uniden 144 and a few other sideband radios.

the directions mention it will work in the cobra 29gtl and ltds but does not mention the tie points.
Would anyone have info on the cobra 29 install for the N kit?

thanks