You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Modifications I removed:

Resistor/diode combo mod removed from bottom of AF regulator over to the modulation transistor.

Replaced 10k resistor (wasn't factory) in R238 location back to a 5.6k resistor.

Replaced 1k resistor (not factory) in R174 location to a 5.1k resistor.

Replaced 3.3k resistor (not factory) in R187 location to a 5.1k resistor.

Replaced limiter.

Replaced R249.

Reset bias.

Proof in itself from before results to after results that running these radios balls to the wall for watts doesn't compare to just a simple recap and complete alignment. I got more watts, cleaner watts, less heat buildup with just bringing it back to stock, recapping and complete alignment.

Again I ask,
Why run these radios balls to the wall?

[QUOTE="Hawkeye351, post: 855123, member: 61115"] Modifications I removed: Resistor/diode combo mod removed from bottom of AF regulator over to the modulation transistor. Replaced 10k resistor (wasn't factory) in R238 location back to a 5.6k resistor. Replaced 1k resistor (not factory) in R174 location to a 5.1k resistor. Replaced 3.3k resistor (not factory) in R187 location to a 5.1k resistor. Replaced limiter. Replaced R249. Reset bias. Proof in itself from before results to after results that running these radios balls to the wall for watts doesn't compare to just a simple recap and complete alignment. I got more watts, cleaner watts, less heat buildup with just bringing it back to stock, recapping and complete alignment. Again I ask, Why run these radios balls to the wall? [/QUOTE]

Top Bottom