T
txranger225
Guest
I started my Phantom 10 tuber one morning and heard some arching on the back side where the group of 4 tubes are. I looked inside and i could see one of the tubes connected to the group of 6 tubes was very bright then it dimmed out and off. at this point i could not key any watts on the high side. the low side seemed to be working just fine. i shut it down and replaced the bad tube, checked the other 9 tubes which all seem to be ok. turned the amp back on and the low side works just fine but the high side only keys about 35 to 50 watts. i looked at the bottom of the amp and dont seem to find any burned parts. i unsaudered the diodes all the little black diodes with the grey stripe on one side and all seem to be ok. i see contnuity going one way an all the diodes.....
anyone know what else i can check?
any help is apprecieated........or anyone willing to trade your good phantom 12 tuber for my 10 tuber please contact me asap...hehehehe.......texasranger225@yahoo.com
</p>Edited by: <A HREF=http://pub86.ezboard.com/bworldwidecbradioclub.showUserPublicProfile?gid=txranger225>txranger225</A> at: 1/7/04 10:33 am
anyone know what else i can check?
any help is apprecieated........or anyone willing to trade your good phantom 12 tuber for my 10 tuber please contact me asap...hehehehe.......texasranger225@yahoo.com
</p>Edited by: <A HREF=http://pub86.ezboard.com/bworldwidecbradioclub.showUserPublicProfile?gid=txranger225>txranger225</A> at: 1/7/04 10:33 am