You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

yes the mod warns of the different pinouts, and they indicate that you should cross the two legs to make it correct, I intended on soldering a short lead of 14GA. wire from each leg and then sliding just enough shrink sleeve tubing over each leg and then cross the two legs that are incorrect and then soldering them to the solder side of the board, then of course putting sum epoxy on the front of the mrf497 and bonding the 1n914 diodes to the Mrf 497's. I think that should do it quite nicely? And by the way

[QUOTE="FULL_MEDIC, post: 646500, member: 53565"] yes the mod warns of the different pinouts, and they indicate that you should cross the two legs to make it correct, I intended on soldering a short lead of 14GA. wire from each leg and then sliding just enough shrink sleeve tubing over each leg and then cross the two legs that are incorrect and then soldering them to the solder side of the board, then of course putting sum epoxy on the front of the mrf497 and bonding the 1n914 diodes to the Mrf 497's. I think that should do it quite nicely? And by the way:giggle: [/QUOTE]

Top Bottom