You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Well I just measured the jack on my Yaesu G-2800DXA rotator I have in the basement and it is NOT the same size. Yours measures 13/16 of an inch and mine is only 5/8 inch. Also mine has four key ways in it to ensure proper alignment when inserting the plug. The pin arrangement looks the same however. Also take note that the rotator housing on both yours and mine is flattened where the connector is mounted. A normal flat based bulkhead or panel mount connector will work perfectly. No need for shims etc as the surface is flat and not curved.

[QUOTE="Captain Kilowatt, post: 633349, member: 39"] Well I just measured the jack on my Yaesu G-2800DXA rotator I have in the basement and it is NOT the same size. Yours measures 13/16 of an inch and mine is only 5/8 inch. Also mine has four key ways in it to ensure proper alignment when inserting the plug. The pin arrangement looks the same however. Also take note that the rotator housing on both yours and mine is flattened where the connector is mounted. A normal flat based bulkhead or panel mount connector will work perfectly. No need for shims etc as the surface is flat and not curved. [/QUOTE]

Top Bottom