You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Well I see my parallel 50 ohm harness shows about half of the two parallel 50 ohm loads in my example above, so I guess 'Doc and NB were correct. I stand corrected, a transformer should show 100 ohms if the load is 50 ohms, and when run in parallel the net load results will be 50 ohms.

Sounds reasonable to me, but I always imagined this thing backward I suppose.

What is a great tip Bob, thanks. No wonder Autek is so willing to fix it for a nominal charge, over $50 dollars plus shipping both ways. I'll try to clean mine.

Are you telling me that this part of the meter is rubber, like latex?

Thanks for the tip and the advice.

[QUOTE="Marconi, post: 352117, member: 903"] Well I see my parallel 50 ohm harness shows about half of the two parallel 50 ohm loads in my example above, so I guess 'Doc and NB were correct. I stand corrected, a transformer should show 100 ohms if the load is 50 ohms, and when run in parallel the net load results will be 50 ohms. Sounds reasonable to me, but I always imagined this thing backward I suppose. What is a great tip Bob, thanks. No wonder Autek is so willing to fix it for a nominal charge, over $50 dollars plus shipping both ways. I'll try to clean mine. [B][I]Are you telling me that this part of the meter is rubber, like latex?[/I][/B] [B][/B] Thanks for the tip and the advice. [/QUOTE]

Top Bottom