You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

If you're going to have those kinds of issues, with just barrel connectors,

Might want to get a 17/19mm and another to fit the "flat" on the threaded - get after that SO-239 and tighten the flange down to that back panel - it's only aluminum and also Anodized...do this tightening- so it doesn't generate this again.

Even tighten those board screws too...

[QUOTE="Handy Andy, post: 787292, member: 52309"] If you're going to have those kinds of issues, with just barrel connectors, Might want to get a 17/19mm and another to fit the "flat" on the threaded - get after that SO-239 and tighten the flange down to that back panel - it's only aluminum and also Anodized...do this tightening- so it doesn't generate this again. Even tighten those board screws too... [/QUOTE]

Top Bottom