You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

I use an Eznec split feed point feature to get the feed point in the center of the model I posted. I think if you make the 4Nec2 model using two elements it automatically sets the split if it is in the center.

Setting the FP on one of the wires will make no difference to the gain or angle, but it will make a small difference in the current distribution...and you can see that in the currents log.

DB, my only hope here is to see if 4Nec2 handles the current distribution on a two wire dipole with two end 1's, or two end 2's, connected...just like my Eznec does. If it does then you can change the end of one leg and make an end 1, connected to an end 2, and check it out with your software and report.

[QUOTE="Marconi, post: 494915, member: 903"] I use an Eznec split feed point feature to get the feed point in the center of the model I posted. I think if you make the 4Nec2 model using two elements it automatically sets the split if it is in the center. Setting the FP on one of the wires will make no difference to the gain or angle, but it will make a small difference in the current distribution...and you can see that in the currents log. DB, my only hope here is to see if 4Nec2 handles the current distribution on a two wire dipole with two end 1's, or two end 2's, connected...just like my Eznec does. If it does then you can change the end of one leg and make an end 1, connected to an end 2, and check it out with your software and report. [/QUOTE]

Top Bottom