You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

I would love to know Henry's thoughts on this model. That being said, at the same time I wouldn't blame him on not wanting to dive into this mess...

@ DB,

Perhaps u could run the model again.
But this time include material losses.

- Go to the new editor menu
- Select source / load (select "show loads")
- Adjust "type" to wire conductivity
- Adjust "cond" to aluminium t6

Thats it...now im moving myself away of the mess again hihi.

hope it is of use...

Kind regards,

Henry

(added: "select show loads" to make it more clear)

[QUOTE="Henry HPSD, post: 498383, member: 2333"] [I]I would love to know Henry's thoughts on this model. That being said, at the same time I wouldn't blame him on not wanting to dive into this mess...[/I] @ DB, Perhaps u could run the model again. But this time include material losses. - Go to the new editor menu - Select source / load (select "show loads") - Adjust "type" to wire conductivity - Adjust "cond" to aluminium t6 Thats it...now im moving myself away of the mess again hihi. hope it is of use... Kind regards, Henry (added: "select show loads" to make it more clear) [/QUOTE]

Top Bottom