You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Henry I did as noted above.

The txt file uploaded and went into Eznec fine, but it does not look like an antenna, and I can't scan it, because Eznec reports the source is incorrectly placed. I converted from mm to feet and the model shows wires 1749' feet long and wire diameter 549" thick. This looks like the dimensions did not come over correctly.

I put the model into one of my models and selected...to replace the wires in my model. I did not check what dimensions either models were set at.

I'll try it again.

I would try to load it into 4Nec2 like I think you did, but I don't know yet how to manipulate the models easily.

[QUOTE="Marconi, post: 498523, member: 903"] Henry I did as noted above. The txt file uploaded and went into Eznec fine, but it does not look like an antenna, and I can't scan it, because Eznec reports the source is incorrectly placed. I converted from mm to feet and the model shows wires 1749' feet long and wire diameter 549" thick. This looks like the dimensions did not come over correctly. I put the model into one of my models and selected...to replace the wires in my model. I did not check what dimensions either models were set at. I'll try it again. I would try to load it into 4Nec2 like I think you did, but I don't know yet how to manipulate the models easily. [/QUOTE]

Top Bottom