You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Separated the coil a "cunt hair" and as you can see in the pic tuned for max smoke the capacitors beginning to mesh.
I'm thinking I should separate it a half cunt hair more. I'm Using a 1500 watt dummy load and my Autek wm 1 and am seeking a bit more dk then before. I left the demco turned off and did not attempt to over couple or modulate into the amp.
I'll wait for your suggestions. If I don't get anything back within a half hour I'll separate the coil a bit more, tune it up and check how it's meshed. It's obviously meshed greater than it was before the coil separation. PICTURE#1 BEFORE SEPARATION (max smoke). PICTURE#2 AFTER SEPARATION.(max smoke).[ATTACH=full]19673[/ATTACH][ATTACH=full]19674[/ATTACH]

[QUOTE="Sonar, post: 571230, member: 47153"] Separated the coil a "cunt hair" and as you can see in the pic tuned for max smoke the capacitors beginning to mesh. I'm thinking I should separate it a half cunt hair more. I'm Using a 1500 watt dummy load and my Autek wm 1 and am seeking a bit more dk then before[SIZE=16px]. I left the demco turned off and did not attempt to over couple or modulate into the amp.[/SIZE] I'll wait for your suggestions. If I don't get anything back within a half hour I'll separate the coil a bit more, tune it up and check how it's meshed. It's obviously meshed greater than it was before the coil separation. PICTURE#1 BEFORE SEPARATION (max smoke). PICTURE#2 AFTER SEPARATION.(max smoke).[ATTACH=full]19673[/ATTACH][ATTACH=full]19674[/ATTACH] [/QUOTE]

Top Bottom