You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

OK I have a Non Hand Wired D201 that I believed to have a bad 455KHz Can (T401). I installed a new known working one and I'm getting the same very low tone. I have my signal generator set at 30% Modulation, 455Khz and +3.0dBm and can barely hear it. I hooked up my Oscilloscope to V401 pin 2 and I can see the 455Khz and Im able to peak L400 and T400 using the scope but audio doesn't change. I try to adjust T401 with the Scope probe hooked to V401 pin 2 and I get NOTHING . When the scope is hooked to the T410 itself I get erratic readings from 100Khz to 900Khz.
Also the meter is pinned far right but rests at zero when off. I tried adjusting R422 but it does nothing.

[QUOTE="Crambone, post: 694613, member: 54145"] OK I have a Non Hand Wired D201 that I believed to have a bad 455KHz Can (T401). I installed a new known working one and I'm getting the same very low tone. I have my signal generator set at 30% Modulation, 455Khz and +3.0dBm and can barely hear it. I hooked up my Oscilloscope to V401 pin 2 and I can see the 455Khz and Im able to peak L400 and T400 using the scope but audio doesn't change. I try to adjust T401 with the Scope probe hooked to V401 pin 2 and I get NOTHING . When the scope is hooked to the T410 itself I get erratic readings from 100Khz to 900Khz. Also the meter is pinned far right but rests at zero when off. I tried adjusting R422 but it does nothing. [/QUOTE]

Top Bottom