• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

X50c2 diamond vhf/uhfantenna


I’ll see your tuned for commercial (I didn’t pay attention as usual) and I’ll raise you this one.


Which I think is the same antenna actually.
I’m trying to find one with a spread wide enough to cover 2m/frs and 70cm/gmrs. I’m using a jpole now. Does fine. Just looking. Might not do me any better. I dunno.
 
I dunno. I don’t know that I’ll really improve over what I have in place already. I’ve a tram vhf ground plane because I wasn’t planning on doing any 70cm. Now I’m playing with it so I made a jpole for a dual band. Both feed points are the same height and on 2m there’s some difference but not too much. However the jpole will work gmrs and 70 so now I have 2 up. It’s using coax that was for the other radio. But will a bought dual band be any better than the 3/8 all thread jpole?
 
16949773939049025816238136423888.jpg


Looks like above 450Mhz would not work as the swr would be too high. Sorry.
 


Anyone tried one for vhf/uhf base operations? Thoughts, opinions so on??

That is simply the commercial version of the Diamond X50 2m/70cm antenna. I have one but I only tried it a short while about 15 feet high. It is going on the tower next year at about 70 feet with 1/2 inch LDF-4 heliax feedline. It should work well.
 
  • Like
Reactions: Cable Guy

dxChat
Help Users
  • No one is chatting at the moment.
  • @ ShadowDelaware:
    AKA- UDX122
  • @ ShadowDelaware:
    West indies and Australia coming in to South Jersey
  • dxBot:
    c316buckeye has left the room.
  • @ nfsus:
    Arkansas skip has been heavy at nights here lately. Australians all over the place
  • dxBot:
    RFactive has left the room.