You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
channel display was working . till i changed out the lite bulb rx/tx.
now the channel display doesn't work. replaced with a new channel display and still not working.
where and what would i look to check.
thanks
allen
i have a meter. but your saying to just leave L6 alone. just clip D14. i just did front panel off and i see there is no way of putting blue lite in it.
help
just clip the d14.(right) L5 just spead the copper wire. L6 is marked on board by final, but it must be the pot full of wax correct. if so just heat wax to remove it.
let me know
thanks
al
about that your right on red to switch and black to ground. BUT if you look at the pc board behide the meter ,there is no switch on the board. JUST THOUGH I LET YOU ALL KNOW.
959 there was no bulb in it. so i looked at the cbtricks web and found pcb ept55v-51z board which looks just like i got. but where they are showing bulb goes. i try it and no go with 12 volt bulb. there is no solder at those little holes either. could it be one of the resitors burn out before it...
on a 959. is the meter lite a 12 volt or 18 volt. also how and where can i hook a lite up on the meter board for it to dim. where can i buy these bulbs.
thanks
lord
where did u hook up wires at for in and out audio.
when i hooked up at the microphone jack board. the radio transmits for a while and then stops transmitting and no talkback. is there another place to hook up the wires at.
on 959
148 nw st mic. wiring question.
is it a 4 or 5 pin radio. my is 4 pin.
if 4 pin hooking up to a cobra microphone.
pin
1 shield, 2 audio white, 3 transmit red, 4 rec. black.
if its not this please let me know. thats the way i solder microphone and no transmit.
thanks
al
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.