Henry 2.5KW Amp
Description:
Rackmount 2.5KW RF generator designed to operate on the 27.12 Mhz ISM frequency and used for medical and industrial use. Basically, it consists of a linear power supply (massive...) at the bottom of a 4.5-ft rackmount on wheels.
The PSU powers a Henry model 2500PGC-27 exciter/amp assembly. Has Bird slugs and associated RF plumbing.
Original mfg.: Applied Research Laboratories Inc.
Consisting of::
Henry 2500PGC-27 RF Amp (tunable). Uses rebuilt Eimac 3CX3000A7 triode.
Power Supply input: 220VAC 36A 47-63 Hz single-phase
Mfg. Date: 1988
RF Output: 2.5KW 27.12
You could get 220VAC 50A service for your laundry room and run this!!
As far as I can tell, everything is complete. You don't have to sweat out finding the hard-to-get filament transformer, etc. I do not have the technical manual or schematic. I do have pictures. Needs about 10-15 hours of clean-up and check out. Unit is air-cooled with a rear-mounted blower assy.
The plate voltage is 4KV and whoever buys this is going to need to be electrically competent or you could be killed! Will not sell to anyone who is not competent or appears to be psychologically unstable due to the serious nature of RF energy involved as well as other misuse. This is a perfect conversion project for a club, etc.
Pictures available.
FOB Minnesota
Heavy Hitter
Description:
Rackmount 2.5KW RF generator designed to operate on the 27.12 Mhz ISM frequency and used for medical and industrial use. Basically, it consists of a linear power supply (massive...) at the bottom of a 4.5-ft rackmount on wheels.
The PSU powers a Henry model 2500PGC-27 exciter/amp assembly. Has Bird slugs and associated RF plumbing.
Original mfg.: Applied Research Laboratories Inc.
Consisting of::
Henry 2500PGC-27 RF Amp (tunable). Uses rebuilt Eimac 3CX3000A7 triode.
Power Supply input: 220VAC 36A 47-63 Hz single-phase
Mfg. Date: 1988
RF Output: 2.5KW 27.12
You could get 220VAC 50A service for your laundry room and run this!!
As far as I can tell, everything is complete. You don't have to sweat out finding the hard-to-get filament transformer, etc. I do not have the technical manual or schematic. I do have pictures. Needs about 10-15 hours of clean-up and check out. Unit is air-cooled with a rear-mounted blower assy.
The plate voltage is 4KV and whoever buys this is going to need to be electrically competent or you could be killed! Will not sell to anyone who is not competent or appears to be psychologically unstable due to the serious nature of RF energy involved as well as other misuse. This is a perfect conversion project for a club, etc.
Pictures available.
FOB Minnesota
Heavy Hitter