Hi everyone. I have always wondered how to do this.
I have a reallly nice microphone at 150 ohms impedance, trying to match it to a rig at the standard 600 ohms.
Everything I have read says that it really should not matter.
However, I get very low output from the mic. When I connect it to a pre-amp I get a lot of squeal.
What is the method or circuit you have to build to match a mic to a rig?
Thanks!
I have a reallly nice microphone at 150 ohms impedance, trying to match it to a rig at the standard 600 ohms.
Everything I have read says that it really should not matter.
However, I get very low output from the mic. When I connect it to a pre-amp I get a lot of squeal.
What is the method or circuit you have to build to match a mic to a rig?
Thanks!