just throwing this out there to see what may be offered:
***davemade (joe/nc) m400 1-2290 x 4-2879 with remote switch. approx 7 years old, case in decent condition, no dents. run ONLY with grant xl (not being offered), less then 20 watts AM pep, and less then 3 watts carrier. basically never been abused, interior as received from joe. palstar 150m(not offered) shows the typical 800 watts pep AM with 200 watts carrier
***magnum S9 purchased spring 2004. never mobile, spent 99% of its life in box on shelf. still have box & extra faceplate. only mod ever was conversion to export, nothing else touched, virgin & unmolested. works as expected, no miracle radio
***magnum 257 2nd version, blue lites & mosfets. this radio was converted to export & used mobile-99.9% of the time on 10m, has some marks on bottom cover. this radio was repaired by magnum tech rick jordan in DE-
'We have examined your radio, and submit the following estimate for your consideration:
1. Parts - Volume Control, SMT resistor $5.00
2. Labor - Replace volume control, repair defective MCU board connections, replace broken SMT resistor, make any applicable factory revisions, check radio for proper operation $35.00
3. Return shipping - $17.00'-
sam would NOT cover it, so it cost me $$$ out of pocket. worked flawlessly before & since. as a base it's a great radio, as a mobile it's just too noisy here in metropolis, but it never failed to perform on 10m.
***i have 2-siltronix 1011-c's. one works & transmits with low output. other 1, i'm not sure. both are in decent physical shape for 35 year old cb's. have some type of desk mic for each.
***my personal, 2nd owner FT101e with 11m, 26.5, 27 & 27.5 xtals installed, have the 2 10m xtals that are out, AM filter, proceesor. i purchased this radio in 1976 from a ham for $750...i think. i used it on 11m regularly til about 10 years ago. in mid 90's, i shipped it to LC at maycom in MI where he went thru it, i THINK replaced a/some tubes. it performed flawlessly til i started using my ar3500(not offered) as a more modern radio. about 5 years ago i shelved it because of low receive. i replaced FET & it was good for a few months then low receive condition repeated itself. gave it to a local who replaced FET again along with several caps. worked great til this past summer, i would assume it should really be fully re-capped at this point. this radio has the plastic on front, includes yaesu desk mic, factory handheld mic & the external speaker housing, speaker long since blew out. and while maybe not 'mint', is probably the BEST looking 101e i've seen in....30 years.
***well used 25 watt ar3500, 4 pin mic connector, no options. xmits & receives, the split/prg round pushbutton was replaced with a silver button & some holes were drilled in the cover for....noise toys, not included. this radio works & with some TLC should be as good as any 3500. it is in fair condition-i've seen FAR uglier on ebay.
***NIB unused mfj 906 6m antenna tuner
***at least a half dozen turner +2 desk mics. all worked, all in decent or better condition
***i have 2 johnson viking 4740 40ch + ssb mobiles, both in real good physical shape, 1 has a matching PS/console unit. neither xmit, the 1 without PS has speech processor, open clarifier, used to be a screamer back in the 70's. neither have worked in years & i have no time or desire to even see why.
***NIB unused shure 526t super punch
***NIB unused chipswitch & 64 pin socket
i am being perfectly honest, i do not NEED to sell these items. while i am not trying to retire on their sale, i am not giving them away either. i won't reply to lowball offers, so be reasonable. shipping would be from the northeast. i may be offering some 'projects', but i do NOT want to take on any projects, i MAY be interested in trades, including:
texas star dx500v or dx1200, als 500 or 600, optima mk3, pdl2, cushcraft a144-7s, m2 6m5x, 3 or 4 sections rohn 25g, archery equipt.....let me know what you may have
***davemade (joe/nc) m400 1-2290 x 4-2879 with remote switch. approx 7 years old, case in decent condition, no dents. run ONLY with grant xl (not being offered), less then 20 watts AM pep, and less then 3 watts carrier. basically never been abused, interior as received from joe. palstar 150m(not offered) shows the typical 800 watts pep AM with 200 watts carrier
***magnum S9 purchased spring 2004. never mobile, spent 99% of its life in box on shelf. still have box & extra faceplate. only mod ever was conversion to export, nothing else touched, virgin & unmolested. works as expected, no miracle radio
***magnum 257 2nd version, blue lites & mosfets. this radio was converted to export & used mobile-99.9% of the time on 10m, has some marks on bottom cover. this radio was repaired by magnum tech rick jordan in DE-
'We have examined your radio, and submit the following estimate for your consideration:
1. Parts - Volume Control, SMT resistor $5.00
2. Labor - Replace volume control, repair defective MCU board connections, replace broken SMT resistor, make any applicable factory revisions, check radio for proper operation $35.00
3. Return shipping - $17.00'-
sam would NOT cover it, so it cost me $$$ out of pocket. worked flawlessly before & since. as a base it's a great radio, as a mobile it's just too noisy here in metropolis, but it never failed to perform on 10m.
***i have 2-siltronix 1011-c's. one works & transmits with low output. other 1, i'm not sure. both are in decent physical shape for 35 year old cb's. have some type of desk mic for each.
***my personal, 2nd owner FT101e with 11m, 26.5, 27 & 27.5 xtals installed, have the 2 10m xtals that are out, AM filter, proceesor. i purchased this radio in 1976 from a ham for $750...i think. i used it on 11m regularly til about 10 years ago. in mid 90's, i shipped it to LC at maycom in MI where he went thru it, i THINK replaced a/some tubes. it performed flawlessly til i started using my ar3500(not offered) as a more modern radio. about 5 years ago i shelved it because of low receive. i replaced FET & it was good for a few months then low receive condition repeated itself. gave it to a local who replaced FET again along with several caps. worked great til this past summer, i would assume it should really be fully re-capped at this point. this radio has the plastic on front, includes yaesu desk mic, factory handheld mic & the external speaker housing, speaker long since blew out. and while maybe not 'mint', is probably the BEST looking 101e i've seen in....30 years.
***well used 25 watt ar3500, 4 pin mic connector, no options. xmits & receives, the split/prg round pushbutton was replaced with a silver button & some holes were drilled in the cover for....noise toys, not included. this radio works & with some TLC should be as good as any 3500. it is in fair condition-i've seen FAR uglier on ebay.
***NIB unused mfj 906 6m antenna tuner
***at least a half dozen turner +2 desk mics. all worked, all in decent or better condition
***i have 2 johnson viking 4740 40ch + ssb mobiles, both in real good physical shape, 1 has a matching PS/console unit. neither xmit, the 1 without PS has speech processor, open clarifier, used to be a screamer back in the 70's. neither have worked in years & i have no time or desire to even see why.
***NIB unused shure 526t super punch
***NIB unused chipswitch & 64 pin socket
i am being perfectly honest, i do not NEED to sell these items. while i am not trying to retire on their sale, i am not giving them away either. i won't reply to lowball offers, so be reasonable. shipping would be from the northeast. i may be offering some 'projects', but i do NOT want to take on any projects, i MAY be interested in trades, including:
texas star dx500v or dx1200, als 500 or 600, optima mk3, pdl2, cushcraft a144-7s, m2 6m5x, 3 or 4 sections rohn 25g, archery equipt.....let me know what you may have