Search results

with the 101e if i set the ic ma as the book says for am no more than 110ma that is 10 watts which gives me the 75 watts dead key on the low side and with modulation talking 110 watts pep is 320 but with my 148 gtl 200-watt dead key talking shy of 300rms at 800+pep but I'll leave as it is and...

75 watts dead key talking around 110 watts RMS

yes that's about what i see also on am pep on bird meter i went ahead and purchase a new set of tubes just to have for backup

Today i finished cleaning my FT101-E and got it on June 26 it was dusty inside and the bottom needed cleaning too. I checked the tubes and they seem in good condition. On AM 110ma setting, which is equivalent to around 10 watts, I am able to talk at a power level of close to 28 average watts...

if you are asking about output power I'm getting at 1 1/2 watts talking almost 4 at 2 to 3 watts talking 6

ok thanks

thanks, Mike what size resistor 1 watt, 2 watt

I discovered a faulty solder spot on the bottom of L22 which caused it to drift. Whenever I applied slight pressure on the L22 tower, it would come back on frequency.

i assume it has to be built I'll ask an amp builder a friend of mine knows here in fl

I have a question about the Palomar 300A. Which capacitor should be replaced to allow for a higher dead key from my radio? Currently, a dead key of 1 1/2 watts from the radio results in a 200-watt dead key on high from the amp. I would like to use 2 1/2 to 3 watts, dead key as it makes my radio...

so all the ones i see batt wire are up midway not towards bottom

here is the inside of original 575-m6 you see where the batt wires are solder compare to the one I posted that's why I was leary of it

yes he is $89.00 he is on FB in all the CB groups buy&sell and so on he lives right in Mulberry Ohio Eugene De

I came across a skilled individual name Eugene de. He is always customizing and enhancing CB radios. he recently worked on an Astatic 636L microphone, adding amplification and tone and volume control. check out the video .click on the word google photos =...

I contacted the seller and informed them that I made a mistake with my bid. I requested to cancel it and felt relieved once it was done.

I placed a bid on a microphone, but upon zooming in, I suspect it might be a fake. It appears as though someone created it using a 3D printer, and upon examining the soldering for the battery wires, I have my doubts about its authenticity. and no stickers even on volume take a look=...

I'll have to wait until the temperature returns to the usual 80 degrees here in Florida before I can begin tracing it. It's too hot in the garage. Thank for the replies

would it be possible for the tunning can be going bad ?? am doesn't do it USB doesn't do it either

Today, while using my 2K on 38 LSB, I left it on for a few hours. When I came back, I noticed that the frequency had drifted up. I attempted to re-tune L22, but the issue persisted. after sitting Is there a method to make the slug a little tighter? I attempted to do so, but it did not work.