Search results

so I've been hanging out on LSB 27.38 and have made contact a few times with just the ft-101e i notice it is a totally different way of talking there compare to AM i have caught myself a few times talking as if i was on am LOL now to learn CQ,CQ,CQ

i have this Astatic 575 m6 mic with the newer board i notice the push-to-talk button is sort of scratchie when squeeze the audio quality is very clean and clear from the on-air reports. the housing is nothing to write home about the front grill has a brownish look to it like the black paint is...

Of all the adapters i have laying around closest one, i found is 12 volts at 1amp i think i need closer to 0.3amps

if you get a chance can you upload a pic of it ?? thanks is it ac to ac or ac to dc

blends right in

what is the rating of the power adapter that you use are they original

radio is sold

i haven't figured out about what it means about the years Covers all questions in the current FCC Technician Question Pool 2022-2026 Covers all questions from the new FCC General Question Pool 2023-2027 FCC Amateur Extra Question Pool 2020-2024

it doesn't come with the power adapter but i see that the center is negative and the outer is positive i found an adapter 12v at 1amp have to reverse the wires

so i just pick up this meter. went to the eham.net website it seems this is a very close to the accuracy meter as the $500.00 one's anyone here ever owns one can tell me about the plus and minuses of it if any will look good on top of my ft-101-e

after 50 OCD kick-in simple fast and effective is the new choice LOL

i was thinking of a resister but got stuck on a value

ok so i took the mic element from this stock mic and wire a 3.5mm to the plus and minus where the element, was so i can use it with a cellphone when tuning a radio the question is do i need to add a cap or resistor parallel to the plus and minus for a cleaner audio output

does it matter on the sequence i usually start on 48,47,46,45, then L38

well, she is all fixed turns out tr-24 was put in backward. i mean there is a image on the board that shows the orientation of it.

thanks will check it out

thanks will look at it when the temp goes down a bit i replace tr34 cause the middle leg had been cut then solder back but no change

ok on my Cobra 2000 gtl i need help or guidance on how to balance the power output from channel 1 to 15 I'm seen close to 15 watts rms the higher I go on freq power start to drop I've done these 2 mods but no change= IC-5 tx-mixer change R190 from 100 to 47ohms then put a 330ohm from pin-5 and...

in the Yaesu line the ft-101e there is a guy here in fl that's all he only works on, just had mine service by him he has a FB page call keeping the Yaesu ft-101 alive

thanks, i have a very good feeling failure is when you don't try.