Nice job!
You should sell those.StarBusters by Redbeard. Coming soon to WWDX!
I can hear members reaching for their wallets.
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
11 meter is very quiet?
- Thread starter Tweetybird
- Start date
Nice job!
You should sell those.StarBusters by Redbeard. Coming soon to WWDX!
I can hear members reaching for their wallets.
Trade Secrets. Those washers were used for holding wire mesh to reactor wall. Had bolt bag on my harness loaded while hanging from a Spider inside reactor. Had a few leftover.....that was 15 years ago.Nice job!
StarBusters by Redbeard. Coming soon to WWDX!
I can hear members reaching for their wallets.
Have thought of building a few radiator hubs for use. But stuff like that ends up being stored away or given to others.
I does....when band is open. No trees dwn here, mid coast Texas, so the mast is a Redbeard Drill Pipe Breakover #1. Redbeard Drill Pipe Breakover #2 has completed preliminary drawings and submitted for review to the Redbeard QA/QC department. Meanwhile, The Redbeard Procurement Dept. has allocated the materials on site. Redbeard Fabricating and Welding is awaiting final review and approval with IFC Drawings.
The StarBuster has talked to West Indies, many states Eastern Seaboard, Midwestern, and Western. Recently, contact many times to South America (Belize)
You got to realize Slow is a truck driver.....
Getting west of Junction, TX on IH10 and winding out Mr Cummins in the pickup to just under 90-mph, 108” antenna attached to bed floor means it’s still there for the stop at Fort Stockton, TX.
In the earlfield I’ve heard some damned impressive bed mount antenna rigs. (Robert, installer at Clays).
Santone to El Paso is close to 600-miles. 35-40 miles on AM 19 ain’t any miracle at night on that road.
.
Yes. And no. I don’t care to imagine the wrench size needed to tighten the proper nut against that washer. Whew!
.
I believe it was 9/16". Like a very large fender washer. We snugged the nuts and killed them.
The center hole is only 1/2". Believe studs were 3/8" all thread. Spot weld to reactor wall. We installed over 500 a night.
Hell....that was years ago.
I've switched radios again. I did recap two linears in the meantime I'm ready to test em
lol....would those "squeals" that you were hearing have been my Brownings? I have been setting a couple up on 38 LSB the last few days lmao. I had a few locals complaining so I went back down to channel 20 AM again...lol
Gawd awful noises....I'll give you my golden screw driver award if you just stop. I'll even give you my golden screw driver. That was such an annoying racket. At least you fessed up to it. Only real skip in days was those squalls of pain emanating from those poor abused brownings.
Got skip.....13:16 / lsb 38. Hit 777 Phoenix, Az. Dayum.....my radio works
They rag chew'n, but have let me know I made "the trip". Not to much into getting outside their circle, it seems. Someone from San Antonio was talking with them, could not hear San Antone. Back outside, cutting pipe for my secret project.
