FS: Palomar 400 Elite 4x SD1446

[CB590]

Up for consideration is my 400 Elite HD. Been running for like 8 months or so as a base setup. Ran with Ranger 296, AT6666 (on low power) and currently Galaxy 86v (on low power). Pre-Amp does work.

Upgraded to a custom built one, so selling this one to fund the other.

Lower 48 states only. PayPal payment as goods and services. Message me for my info. Shipped with tracking.

Asking $265 shipped.

Currently has 10 awg wire on it. You may want to change or just solder the harness on board. No warranties, expressed or implied. Keep drive down to I'd say no more than 25w PEP to keep it clean and AM dk about 2-3w max. in my opinion.

Pics. Vent holes were in cover when I got it.




Here is a video link to functioning. My meter only goes to 300w. This was done in SSB mode to show the swing. I usually run on Medium to keep my meter from "popping".

 

[CB590]

Dropped to $245 shipped.

Somebody help me out, pweaseeee.

 

[CB590]

Dropped to $210 shipped.

 

[Tokin]

Dropped to $210 shipped.

I wish I had the extra cash id buy it just to help you out.
Try Offerup and Letgo for local deals too.

 

[144inBama]

I'll take it....

 

[CB590]

Item is sold.

 

[2NC995]

Good deal.

 

[Freddy Texidor]

Hey Guys,
does anyone know where I can buy the 2 resistors that are solderd to the low side and medium side of switch?

 

[AudioShockwav]

Mouser electronics comes to mind.
They burn up from too much drive.
They simply bleed off some of the drive in the low and med setting.
The last one here I just bypassed the whole switch and went right to the input transformer.


73
Jeff

 

[Freddy Texidor]

Jeff,
Thank you for the resistor info. order and on the way.

Can you please show me how you bypassed the whole switch and went right to the input transformer? What wattage output are you getting out of the amp?
What's the input watts, dk, swinging watts from radio?