Hello all, I have been playing around trying to get my old sb220 working. Just a run down of what’s done inside the box. First off I have 2 mismatched tubes one old eimac and one newer graphite style. Could this be my issue right off the bat? I put in the nomadradio bias board. And it appears someone before me did the “self bias mod” on the relay. Not sure if that conflicts with the nomadradio board. I have 3.4kv plate voltage, under driver I’m pulling both plate and ride current. Driving with 40w rms 80w peak AM. When I key the amp I see no difference in power on the meter. Iv checked the band switch and relay. Any ideas on where to look next are appreciated.
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
-
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!
Help with sb220, zero output power
- Thread starter JimboSlice
- Start date
- No one is chatting at the moment.
-
-
-
-
@ Geoexplorer69:Coax question. I just put up a new Sirio monsoon base antenna with 100’ of rg8u coax testing with myMFJ antenna analyzer shows 1.4 swr at 26.965mhz and a 1.1 at 27.405 mhz . When I checked the ohms it’s steady a 30 ohms across the entire bandwidth.
-
