I have a project that involves filling a small hole with solder. There is a machined surface near it that I really don't want solder to flow on. Anyone have any methods or ideas that might help? Thanks
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
How to stop solder flow?
- Thread starter 338_MtRushmore
- Start date
Traditional method is high-temperature masking paint.
And Vaseline will work until it gets too hot.
73
And Vaseline will work until it gets too hot.
73
Shadetree Mechanic
Delaware Base Station 808
I was going to say to cover it with a metal that solder doesn't stick to. Maybe clamp an aluminum plate to it.
Shadetree Mechanic
Delaware Base Station 808
Shadetree Mechanic
Delaware Base Station 808
Can you post a picture? Now I am really curious.
On a side note about solder, I learned how to solder when I was 10. One day I tried to melt a Lego block with solder by filling up the under side of the block. Well it didn't melt so I picked it up. The block was so hot that I dropped it and spilled liquid solder on the back of my other hand. I still have the scar to this day....
Last edited:
Shadetree Mechanic
Delaware Base Station 808
Tapes that have an adhesive are a bad idea unless you don't mind spending a large amount of time cleaning off afterwards.