-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
-
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!
Monitor Your Ham Radio With An Oscilloscope (VIDEO)
- Thread starter Mudfoot
- Start date
Very cool. I run a Yaesu FT-101ZD in the shack with a YO-901 Scope attached. I have it setup to monitor my output and I can also use it as a band scope to find signals.
I have channel 1 monitoring my tx signal and channel 2 monitors my receiver IF so I can look at the signal of whom I am talking too. My Kenwood TS-820S has the rx IF OUT port.
If I would hook it up to the FT-901dm I am repairing then I could monitor incoming sigs as well but the 101zd wont work that way with the YO-901.
- No one is chatting at the moment.
-
-
-
@ Geoexplorer69:Coax question. I just put up a new Sirio monsoon base antenna with 100’ of rg8u coax testing with myMFJ antenna analyzer shows 1.4 swr at 26.965mhz and a 1.1 at 27.405 mhz . When I checked the ohms it’s steady a 30 ohms across the entire bandwidth.
-
-
