9C1DRIVER I have done several of the newer mosfet radios and have not seen 30-35w peak; but that was without clipping any limiters or modifying the radio beyond a peak and tune and most importantly I ran the radio right at 13.79-80v on my Astron vs-35m during the peak and tune. This is what I ususally see out of the single mosfet radios Ranger 396,966 Galaxy 949,959 is a deadkey = 7-9w, and PEP of 24-28w max with modulation set point at or around 50-62% and swings to 100%. 43315 you should be seeing more than what you are getting so something has not been done, it sounds like the modulation hasn't been turned up and only the power has been. What is your deadkey and then we can tell you where to go from their. The RFX-75 is a very nice addition to the radio, but remember you will totally lose your warranty if this is new and if you install the RFX-75 and it is doa when you install, powerband the manufacture of the RFX will not cover it. The reason being is that they are not intended for the use on this radio but for the final transistor replacement on Magnum radios and you have to modify the RFX-75 to work on yours and cut wires. This will automatically drop the warranty on the Radio and RFX; but it is your call. I have done this to a cobra 29 chrome special edition and never got the numbers that they talk about and I have several other friends that installed them and got very similiar numbers that I did. If you run 13.79-80v supply into the radio you will see similiar numbers to this if installed correctly. Deadkey about 14-15w, the PEP was 75-78w. I was pretty satisfied with these numbers, but was baffled why others were getting bigger numbers and basically I believe boiled down 2 things. 1. The supply voltage was much higher that 13.80v say around 14.4-15.0v, if you ask the shops what supply voltage they use when testing they may all have different numbers.2. Spreading the coils on the RFX-75 before installing could raise the numbers. Be aware you will need all the equipment to re-allign the TX and RX when you put RFX on; and I know that Sparkys when he installs does a good job and charges I believe around $75-100 including the unit you just have to ship to him. I think he will get somewhere around 12-14w dk, 90-95w PEP and that is a ballpark value because I don't know what he runs his power supply at. Well that more than enough you make the call.
