On my conversion board, the diode from pin 1 down to pin 3 is resting on pin 2, I mean it is touching the #2 pin.
Shouldn't I be concerned about it over heating by trying to jump at the con 2 position, well I am.
I'm no expert at soldering, I'm afraid of cooking the diode.
Question #2 ... Would it be OK to unplug, and remove the speaker while I'm here, or would that be ill advised. I will never use it.
Shouldn't I be concerned about it over heating by trying to jump at the con 2 position, well I am.
I'm no expert at soldering, I'm afraid of cooking the diode.
Question #2 ... Would it be OK to unplug, and remove the speaker while I'm here, or would that be ill advised. I will never use it.