You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
i am installing a led to back light my meter on my galaxy 949 I don’t like the stock so I bought one and was going to wire to the board where is a good location to solder the wires????
If your LED is hooked up to the positive side of the power switch and is getting around 13.8v. like the rest of the radio is, then a 680-1000 ohm 1/4 watt resistor will do just fine. The resistor needs to be hooked between the positive 13.8v and the anode of the LED otherwise it will fry.
Look carefully at the inside of your LED clear lens, and you will notice that one side of it is shorter than the other. This is the positive side of the LED (the 'anode'). If you hook it up backwards, it will not work. An LED ('light emitting diode') is basically a diode, and diodes can only conduct current in one direction.
Please advise me to what is a good replacement mic for my SR-497HPC... Answer: 497 is "wired like Cobra", so many choices available. That radio does not need a power mic, so purchase a stock "coffin style" mic with a decent cord, like the ones that Astatic uses. The Superstar DM-507 is my go-to. https://www.ebay.com/itm/3050474478...adANq91JSiEEnz8EGqPJRBloTgEyaVsBoCtoMQAvD_BwE $12.99 + .99 cent shipping.
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.