• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Base New install

jimmy360

Member
Oct 29, 2021
37
4
18
48
Just installed a new patriot antenna 2 stages works very well but I’m confused on the swr my 148gtl swr meter reads 3.0 and when I test the antenna to radio with my Dosey meter in line it reads a flat 1
 

Try another radio with built in SWR meter
and /or another external meter in order for you to discard if it is the radio or the antenna. An antenna analyzer would be best.
 
Ok aquired the sark100 antenna analyzer did a test antenna reads 80 ohms. When I adjust the rings goes higher
 

73
Jeff
Oops link to last page of thread.
 
  • Like
Reactions: Robalo
Actually I linked to the last page not the beginning,
Is were it started.

Obviously something is not right for a 80 ohm reading.
Can you check the coax itself with your analyzer?
Can you measure the antenna at the feed point?

73
Jeff
 
Actually I linked to the last page not the beginning,
Is were it started.

Obviously something is not right for a 80 ohm reading.
Can you check the coax itself with your analyzer?
Can you measure the antenna at the feed point?

73
Jeff
I will do a test today I’ll put a dummyload on one end and check it with analyzer will post my results here thanks
 
Used to work from the radio don’t know what happen any help would be great
There is a Tuning pot inside the radio that is adjustable so never trust the internal meter. A Dosey is not a good wattmeter but it's OK for just SWR readings.
 

dxChat
Help Users
  • No one is chatting at the moment.