-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
fix kenwood
- Thread starter Robert C Tetrault
- Start date
BJ radionut
Supporting Member and 6m addict
Specializing in repair and alignment of Kenwood brand ham radio gear, Jahnke Electronics based in Green Bay, Wisconsin
Ham Radio Repair | HamRepair.com | Professional Amateur Radio Repair
Ham Radio repair of all major brands and models
www.hamrepair.com
He went through my TS 2000 a few years back. Did a good job. Good communication with me and affordable..
Very common with that rig. Worth fixing though.
BJ radionut
Supporting Member and 6m addict
TS-440.
Dreaded DOT syndrome.Much info on the net.
PLL out of lock, if I remember correctly there is 4 or 5 pll in the 440.
The compound, wax looking stuff, Kenwood used to stabilize components in the PLL section turns corrosive after a few decades.
Starts corroding component leads and traces on the board.
Needs repaired and might as well recap it to lower the chance of any future failures.
Lots of info on how to repair it yourself online if you want try do it yourself.
Dreaded DOT syndrome.Much info on the net.
PLL out of lock, if I remember correctly there is 4 or 5 pll in the 440.
The compound, wax looking stuff, Kenwood used to stabilize components in the PLL section turns corrosive after a few decades.
Starts corroding component leads and traces on the board.
Needs repaired and might as well recap it to lower the chance of any future failures.
Lots of info on how to repair it yourself online if you want try do it yourself.
