Anyone have any idea where I might get a rhons 30 push up mast without insane truck shipping? Trying to avoid 200 mile round trip to Dallas etc
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Push up poles locally?
- Thread starter lonestarbandit
- Start date
IRS travel deduction was around 50-CPM last I looked. That’s pretty well a minimal owner/operational cost at 5-years/60k miles.
Shipping is at or under $100? A bargain once your road expenses are factored.
Combining that trip with other “shipping savings” is the only way it works to advantage to make a road trip.
Besides the pleasure, that is.
FWIW, hit the edge of the metro area at just before 0900 (75-miles from downtown) and the travel friction is lowest with departing city center no later than 1400.
Steady-state cruise-control at 64-mph the other part of it. Plan any stops in advance. Never mix with the packs of cars (especially in left lane), and slow 5-7/mph to get the big trucks around fastest.
Ran my 1T in a 350-mile round trip to Houston a few years back. Mechanics appointment early on in outskirts, then into the maelstrom to have a second installation done. Tight planning in all ways. Still averaged above 22-MPG the whole way.
Just barely met the shipping cost of both items. Installation was almost free.
Did I use radio? Oh, yeah, the UNIDEN PC-76 was velcro-strapped to console and a Firestik out on the hood. Performance basically sucked, but route familiar due to big truck work.
HRO and Larry’s CB aren’t far apart relative to coming in from the sticks. If that ain’t incentive, what would be?
DX Engineering offers free shipping. I recently purchased a ROHN push-up mast.
I'm in Waco what size how much? Drop me a pm lol need at least a 20 for my first beam. Have to clear the house roof. I'm down for used. RF doesnt care if its shiny lol
Last edited:
Home Depot.
EMT 1-1/2", 1-1/4", 1" ×10' tubing
Chain link fence post 1-3/8" ×10'
This gets you a 37' tall push up pole
If 1" is too light then use 2" × 10' EMT on the bottom.
EMT 1-1/2", 1-1/4", 1" ×10' tubing
Chain link fence post 1-3/8" ×10'
This gets you a 37' tall push up pole
If 1" is too light then use 2" × 10' EMT on the bottom.
yes that's what I used for the Imax 2000 but want a real collapsible mast for the beam for service
I am not sure that I would put a beam and rotor on a push up. Seems like a temporary situation is better suited for the push up.
I can see why you would think that.
But laying that Imax over and down and missing the power lines near my home is relatively easy.
Doing the same with an unwieldy beam and not damaging it or the chinesium rotor I ordered be it with lateral load or damaging the beam itself going to ground or killing myself on the power lines in the process of lowering not being terribly attractive, I would be better served, I think, by a vertical raise and lower solution vs a lateral.
But laying that Imax over and down and missing the power lines near my home is relatively easy.
Doing the same with an unwieldy beam and not damaging it or the chinesium rotor I ordered be it with lateral load or damaging the beam itself going to ground or killing myself on the power lines in the process of lowering not being terribly attractive, I would be better served, I think, by a vertical raise and lower solution vs a lateral.
