I just got a Wouxun KG-UV2D and a KG-UV3D, both 2/70. I am using the software to program them with identical frequencies. However, when I add a 6 digit "welcome" screen message to the software, it uploads successfully to the UV2D, but not to the UV3D. All frequencies, pl tones, etc, upload identically to both radios.
The UV3D screen at powerup, when set to "welcome" message, reads
UV3D
PROGRM
If I change it to "full screen", at power up it appears that all the pixels on the screen flash (probably normal operation)
If I change it to "power" it flashes the voltage (probably normal operation).
I just can't figure out why the welcome message won't upload/update.
Anyone else experience this?
The UV3D screen at powerup, when set to "welcome" message, reads
UV3D
PROGRM
If I change it to "full screen", at power up it appears that all the pixels on the screen flash (probably normal operation)
If I change it to "power" it flashes the voltage (probably normal operation).
I just can't figure out why the welcome message won't upload/update.
Anyone else experience this?